Bebop 1 and UART after Bebop fails to start

I have a bebop 1 that blinks green no matter how many times I try to reset it.
I have a micro usb flash drive I will try to force it to reinstall the latest Bebop firmware.
( :x: USB method didn’t Work :x:)
If that doesn’t work I have a USB-A to UART cable (ground rx,tx) is that correct wire order when looking at the side of the bebop 1?

What are the steps and code I do after I hook the cable up to get this machine working again?

The blinking bebop fails to take any Bebop 1 firmware from micro usb drive

Looks like my only option is through that uart port.

Again anyone with the procedure methods and code to fix would be greatly appreciated.

Everyone forgot?

This topic was automatically closed after 30 days. New replies are no longer allowed.